Phone: 0418 282 097
Email: gbhaynets@bigpond.com

Measuring your Round Bale to Determine the Net Size Needed

The measurement of the flat side (width) of the round bale will determine the size of the hay net required. This is the most important measurement needed.

The sizes of the hay nets and round bales are given in feet, Eg. A 4x4 round bale is 4 foot wide x 4 foot high, or 1.2m x 1.2m. We have converted these and provided you with them in meters to make it easier when measuring your bales.

The measurements in meters are as follows;

4x4 = 1.2m wide, therefore a 4x4 = 1.2m x 1.2m

5x4 = 1.5m wide, therefore a 5x4 = 1.5m x 1.2m

6x4 = 1.8m wide, therefore a 6x4 = 1.8m x 1.2m

 

In the image below left, the red line illustrates where the measurement is taken to give you the sizing of the round bale.

    

The image above right illustrates the second measurement (height) of a round bale. This measurement is the same for all three sizes of round bales. This measurement is 1.2m (4 foot) and will not affect the size of the net that is required.

 

Sizing:

All of our round bale hay nets are now able to fully encapsulate the round bales as we have done a revamp of all product sizes.  These nets are now more generous in sizing and super easy to put on the round bales and the large square export bales.  Tight nets on bales might look good initially, but to keep our products easy to use throughout their entire life, we recognized they needed to be a bit bigger, so they are all true to size and easy to put on.  For example: if you only ever use 4x4 hay bales/rolls, then you only need a 4x4 hay net.

Please note that the 6x4 is a 'one size fits all hay net' and will fit all sizes of round bales listed above. Obviously it will be big if fitting on a 4x4 for example, however  the excess netting can simply be rolled up along one edge of the net and tied off in a couple of sections using twine to take up the slack.   We send simple instructions on how to do this.

Click here to see our horses eating from a 4cm GutzBusta 5x4 round bale hay net in 48ply.

Because many of our customers are still happy with the 48ply round bales, we are will continue to make these for now in addition to the new 60ply.

Sizes and Range Available:

Round bales and Large Square Export Bales– Available in 3cm, 4cm and 6cm sized holes;

Please note that ALL of the 6x4 hay nets will fit all 3 sizes of round bales as well as the large export square bales (8x4x3 and 8x3x3).

4x4 $127.50 (48ply) 4cm holes (black in colour)

5x4 $137.50 (48ply) 4cm holes (black in colour)

6x4 $147.50 (48ply) 4cm holes (black in colour)

-----------------------------------------------------------

4x4 $147.50 (60ply) 4cm holes (green in colour)

5x4 $157.50 (60ply) 4cm holes (black in colour)

6x4 $167.50 (60ply) 4cm holes (black in colour)

-----------------------------------------------------------
6x4 $160.00 (48ply) 3cm holes (black in colour)
-----------------------------------------------------------

6x4 $147.50 (60ply) 6cm holes (black in colour)

 

Installing your GutzBusta® Hay Net on a Round Bale  

The following is a 4 x 4 Round Bale.

Firstly position your hay roll on its flat side so you can pull off the twine or string keeping it together.  Then put the hay net over onto the top of the bale before you undo strings etc.  If your hay bale stays together once string is removed such as lucerne hay might, then putting the net over first isn't necessary, but some bales such as oaten and pasture fall apart quickly, so this way you have net in place ready to pull down quickly to contain the hay.

Remove the strings or twine keeping your round bale together and start to pull the net down around the bale.

Once the string is removed, you can then pull the netting down the side of the bale to the ground.

Pull your draw string firm at the base and then either undo the knot at the end of the rope and redo it at the base of the net and let the remaining rope be free, or you can simply tie the remaining length of your draw string back up into the net so it is't free to get caught in.  PLEASE NOTE THAT ALL SIZES WILL NOW FULLY ENCAPSULATE THE ROUND BALE.  Once you have the net pulled over the entire bale and down to the ground, you can simply flip the bale over either 90 degrees or 180 degrees and pull up the remaining net to encapsulate the bale.

Your round bale is now ready to go.  Enjoy watching your horses EAT their hay instead of laying on it, pooping on it and weeing on it 🙂

You can then either tie a simple knot in the drawstring at the base of the net (and undo the one at the end of the drawstring) and leave your remaining drawstring free with no knot at the end, or you can secure the drawstring into the hay net. Make sure you don't leave any loops that your horses legs could get caught in.

You may also use the drawstring to do a quick sew of the join if your hay net didn't come together as well as you would have liked.

The following photos show another way to tie off your draw string.

To purchase your GutzBusta® Hay Net, click on this link 🙂